Комплект за извличане на винтове с повреден титан Speed ​​Out, комплект от 4 части

Brand:Speed Out

2.8/5

lv
85.32

Комплект за извличане на винтове с повреден титан Speed ​​Out, комплект от 4 части

Комплект за извличане на винтове: Комплектът за премахване на повредени винтове и болтове Ontel Speed ​​Out лесно отстранява всеки оголен, повреден или счупен винт или болт за секунди; Работи с всякакви бормашини.
Brand Speed Out
Finish Type Titanium
Item model number 1000366
Manufacturer Ontel
Material High quality steel
Package Dimensions 7.09 x 4.69 x 1.77 inches; 4.16 Ounces
Shank Type Straight
Tool Flute Type Spiral

2.8

8 Review
5 Star
51
4 Star
15
3 Star
11
2 Star
7
1 Star
16

Напишете вашето мнение

Вашият имейл няма да бъде публикуван. Всички задължителни полета са маркирани с*

Scritto da: Keelan Krueger
Did not work for me :(
They were easy to use, but I screwed up the situation too bad. I ended up using a rotary tool to cut a slot in the screw head and then used a flathead screwdriver to take it out.
Scritto da: User of stuff
As advertised:
Described them perfectly
Scritto da: Scotty Gray
Great sometimes
These work great sometimes. If you expect them to work 100 percent of the time forget it. Nothing will. But sometimes they do and it will really get you out of a bind. Well worth the cost if they save your but one time.
Scritto da: Josh
Didn’t work- Returned after one use.
Didn’t work at all. Ended up just taking a drill bit to the screw to get it out. This did nothing.
Scritto da: AmznRvw
Didn’t work
I tried using these on some stripped deck screws. Out of 6 it worked once. I watched videos and followed the instructions but for whatever reason all I managed to do is make it completely stripped. Maybe they were rusty and it’s why it failed, not sure. The screws seemed strong enough but maybe I’m wrong
Scritto da: J. M. Crawford
Works well if used as directed
This may sound obvious, but you have to read and follow the instructions. The grippy ends don't grip well if the head isn't properly prepared with the burr ends, and the bits in general don't extract well unless you use a drill at slow speed while applying consistent pressure. Using an impact driver just doesn't work well.
Scritto da: Jacob Forster
Fast and Easy
Removed the stripped screw with no issues. Took about 15 seconds total.
Scritto da: Keith Quirolo
Didn't work for me
Removing rusty screws from an old deck, was unable to get this extractor to work to remove screws that would not come out with the drill... probably works better with a new screw that is not old an rusty. The extractor heated up and was unable to penetrate the screw head. Two stars as maybe it would work for someone else...

Свързани продукти

Открийте нашата международна мрежа

Изпращаме до 28 държави, над 200 000 продукта. Бъдете в течение, абонирайте се за бюлетина.

Array