West System G/Flex Epoxy (2-4oz) ЕДИНИЦИ

Brand:West System

3.9/5

lv
126.35

Епоксидното лепило G/flex принадлежи към комплекта за ремонт на всеки лодкар. Получете водоустойчива, гъвкава връзка върху пластмаса, фибростъкло, алуминий и др. Комплектът 650-8 ви дава две 4 унции. бутилки с течен епоксид. Комплектът 650-8 съдържа 4 унции. всеки от вискозна течна G/flex 650 смола и втвърдител. Съотношението на смесване е 1:1. Смесената G/flex 650 е с плътна консистенция на сироп. Ще изтича от вертикална повърхност. 650 може да се удебелява с инертни пълнежни материали. G/flex е продукт на West System, подразделение на Gouge on Brother's, The Gouge on Brothers използват епоксидни смоли в строителството и ремонта на лодки от около 50 години. Той създава структурни връзки, които могат да поемат напрежението от разширяване, свиване, удари и вибрации. В допълнение към превъзходното си свързване с много различни материали и способността му да свързва различни материали, G/flex е много по-гъвкав от другите епоксиди. Това е отличен имот за строителство и ремонт на лодки. Полиетиленът (HDPE) е често срещан материал за каяк и кану. Неговата молекулярна структура е устойчива на залепване от повечето лепила. G/flex решава проблема; свързва се добре с полиетилен и ABS пластмаси. При 72 F животът е 45 минути. Работното време е 75 минути. Втвърдява се до твърдо състояние за три часа и се втвърдява до пълната си сила за един до два дни. Втвърдява се по-бързо при по-високи температури и по-бавно при по-ниски. Почистването е просто. Избършете разливите с абсорбиращи материали. Почистете остатъците, преди да се втвърдят, с алкохол или ацетон. G/flex прилепва упорито към трудна за залепване твърда дървесина, както тропическа, така и местна. Има способността да лепи влажна дървесина. Може да се използва върху мокри повърхности, дори под вода, когато се прилага със специфични техники. G/flex наистина принадлежи към ремонтния комплект на всеки лодкар. Колкото повече го използвате, толкова повече приложения ще намерите за него - с вашето оборудване за лодка и други спортни и домакински артикули. Лесно се смесва и използва. Инструкциите, които идват с комплекта, са на първо ниво.

Страна на произход: САЩ. G/flex има способността да лепи влажна дървесина. Може да се използва върху мокри повърхности, дори под вода, когато се прилага със специфични техники. G/flex прилепва упорито към трудна за залепване твърда дървесина, както тропическа, така и местна. Това е важно, тъй като много от екзотичните и тропическите видове, които сега се използват за заместване на традиционните дървета, представляват предизвикателства при свързването. G/flex 650 е закалена, универсална, течна епоксидна смола за постоянно водоустойчиво залепване на фибростъкло, керамика, метали, пластмаси, влажна и трудна за залепване дървесина.
Brand West System
Brand ‎West System
Brand Name ‎West System
Color Clear
Color ‎Clear
Compatible Material Plastic
Compatible Material ‎Plastic
Customer Reviews 4.8 4.8 out of 5 stars 1,257 ratings 4.8 out of 5 stars
Included Components ‎Epoxy
Item Dimensions LxWxH ‎3.5 x 7.75 x 1.95 inches
Item Form Liquid
Item Form ‎Liquid
Item Package Dimensions L x W x H ‎7.75 x 3.39 x 1.75 inches
Item Package Quantity ‎1
Item Volume ‎236 Milliliters
Item Weight ‎11.4 Ounces
Manufacturer ‎WEST SYSTEM
Material Epoxy
Material ‎Epoxy
Model Name ‎650-8
Number of Items ‎1
Package Information ‎Bottle
Package Weight ‎0.32 Kilograms
Part Number ‎2270
Size ‎UNITS
Suggested Users ‎Automotive
Water Resistance Level ‎Waterproof

3.9

13 Review
5 Star
87
4 Star
10
3 Star
2
2 Star
0
1 Star
1

Напишете вашето мнение

Вашият имейл няма да бъде публикуван. Всички задължителни полета са маркирани с*

Scritto da: Ramona
It's not cheap but quality never is.
I have used this for a variety of applications requiring robust adhesion and reasonable flexibility. This has not let me down as the other two-part epoxies have. It's West Systems so it's not inexpensive but their quality has been proven over decades.
Scritto da: Chef Steve N
Great stuff
Great stuff!!! Some of the best I’ve used!
Scritto da: Todd A. Rosenthal
Incredibly strong
I have some sagging oak floorboards. I have tried wood glue and other epoxies to fix them. Nothing worked. Then I tried this stuff. Once it hardened no more sagging floor. It is just a bit flexible which is ideal. More brittle glues failed. This is a great product. Best adhesive I have ever used.
Scritto da: Tom H.
Worked well
I like the long cure time. The 50 50 mix must non be critical since I mixed in small batches by eye and it cured well
Scritto da: Sailerman
Best Expoy ever.
Does everything.. But Not for wetting out large sheets of fiberglass or carbon.
Scritto da: Valdon D Teeples
Reliable strong bond that is easy to work with.
I make knives and use this product, along with pins to adhere my multi-piece handles to the blades. Preparation of the surfaces with rough sandpaper and cleaning with acetone is critical. Since I switched to this epoxy over a year ago, I've never had a failed bond. I let it cure for about 6 hours and then use a razor blade to clean up drips and excess epoxy squeezed out by the clamps. It still is pliable to work with at this point. After 24 hours, it is a permanent waterproof bond that has not failed on over 100 knives. I would highly recommend this product.
Scritto da: Harold C. Bacon
Great epoxy slow cure rate
Takes a long time to set but very strong bonding! Bonds steel and resinous woods no problem! Hard finish after setup, some oder but not bad, better than JB imo.
Scritto da: Robert J. Cartano
Way better than tubes
A little more money to start out with but way more. I use on a number of ski repairs and boot repairs and I highly recommend. Hasn't failed me yet. I really like the squirt bottles rather than the tubes that always seem to be no good when I go to use them a second time. I am definitely buying again.
Scritto da: ATC123
Not fast setting
If you want a fairly slow setting epoxy this is the one to use. Even when in a very warm environment, this does not set quickly. It is possible to mix fibreglas into it to thicken it up but otherwise you will need to wait 15 minutes to avoid it running. This is not a criticism since the instructions clearly indicate that it is not a rapid setting epoxy. The bottles it is packaged in make using it very easy, sometimes simple is better. While it indicates that it should bond to PE, after flame treatment, I would not recommend it. I think that it is good value.
Scritto da: DC Knives
Very well suited for knifemaking
Alongside Brownells' Acraglas, this is the best epoxy I have used for attaching knife scales and through and hidden tang kitchen knives. I have some five year old kitchen knives that are holding up just fine. The set time is long (unlike quick five minute epoxies) and this is beneficial for getting things lined up just right before clamping. There is a little more flex in this epoxy compared to Acraglas which is ideal for, beating, pounding, dropping that knives can take.
Scritto da: J
Product does what is says but still isn't suitable for some types of repairs
I used this to repair a polyethylene kayak with a hole worn through the keel. The product dries quickly and hardens like steel. However... The repair is holding and waterproof. But around the edges of the repair you can peel it off with a finger nail. It did not chemically bond to the plastic. Although it's holding for now I have my doubts it will for much future use. I feel like this product is more suitable for repairing tiny cracks. For big jobs you will need something that actually chemically becomes part of the hull. Not something that just sticks to the outside.
Scritto da: Rick Wallach
Worked great on delaminated ski bases
I researched this product and was given some very good advice from the manufacturer. I used it to repair the bases on my xcountry skis. Since using it I have put the skis to a really good test. The result… it works very well. I would highly recommend it.
Scritto da: BobNod
Tough stuff.
I'm repairing a 45 year old Old Town Tripper. It has a vinyl skin inside and out. Vinyl is noted for being difficult to make good bond to, but this stuff works great. Read the instructions first, do all the cleaning and preparing if you want this stuff to do it's best. If you do, it's best is excellent.

Свързани продукти

hot
TotalBoat Elixir Enamel
3.6/5

lv 144.81

TotalBoat Elixir Enamel
3.6/5

lv 144.81

hot
TotalBoat Elixir Enamel
3.6/5

lv 144.81

TotalBoat Elixir Enamel
3.6/5

lv 144.81

Открийте нашата международна мрежа

Изпращаме до 28 държави, над 200 000 продукта. Бъдете в течение, абонирайте се за бюлетина.

Array