Perko 0561DP4CHR Вентилационен отвор за газов резервоар с въртящо се коляно, черен

Name: Perko 0561DP4CHR Вентилационен отвор за газов резервоар с въртящо се коляно, черен
Brand: Perko
SKU: 0085226008481
Price: 106.09 EUR
Availability: InStock

Brand:Perko

3.7/5

lv
106.09

Обработена филтърна среда за улавяне на вода, като същевременно позволява максимална производителност. Кутията е облицована с епоксидна смола за предотвратяване на вътрешна корозия. Пълна единица, включително прикрепваща глава и филтърна кутия. За извънбордови двигатели, I/O и вътрешни бордове.

Количество

Добави в кошницата Купи сега

EAN: 0085226008481

Категории Спорт и дейности на открито, Спорт и фитнес, Водоходство и ветроходство, Лодоходни лодки и оборудване, , резервоари за гориво,

Brand	Perko
Exterior	Plastic,Zinc
Fit Type	Universal Fit
Item Dimensions LxWxH	7 x 3 x 2 inches
Material	Plastic

5 Star

4 Star

3 Star

2 Star

1 Star

Напишете вашето мнение

Вашият имейл няма да бъде публикуван. Всички задължителни полета са маркирани с^*

Вашата оценка

Scritto da: John F.

Perko 0561DP4CHR Gas Tank Vent with Swivel Elbow , black

Not easy to install, but that is the boat manufacturer's fault. Instructions call for "bedding" material to be used inside between the washer and the sidewall; I used a sealant. This should work fine and won't fall off.

Scritto da: James

Good for 20 years

The salt environment will eventually corrode these. However, the previous vents lasted over 20 years. The reason that these are not that easy to install is not the fault of Perko but to the boat builder that places these vents in difficult to access places.

Scritto da: c. brendal

Gas Tank Vent

I fit like a glove in the original hole. It helps to have a boat that has lots of room to install this but it works great.

Scritto da: Joseph Kubinski

Exact replacement for failed unit

The vent perfectly replaces the existing unit which corroded away after 20 years, and looks identical from outside the boat. Installs easily as the outside vent piece slips over the inner protruding tube fitting, and is tightened from inside. Only downside is that it is still zinc die cast with chrome plating, which means only another 20 years before replacement. Won't be my problem by then! ????

Scritto da: M_Fite

Good Product

Holding up well with no issues.

Scritto da: Hal Clay

It does the job. Cost less than other models.

It looks just like my original. No issues.

Scritto da: captain Jim

Good product

I installed two of these on my charter boat which gets a lot of use. After a month I lost one of the chrome caps. Make sure you tighten the nuts and use a little thread locker on it to prevent this from happening. Haven’t had a problem since. Keeps all water out of the tank. Best design in my opinion.

Scritto da: Michael

Fit my trophy boat

Worked fine, as expected. 1999 2052 trophy.