Lutron Diva 250W LED+ димерен превключвател за димируеми LED, халогенни и крушки с нажежаема жичка, еднополюсен или 3-посочен, DVCL-253P-BL, черен

Brand:Lutron

3.6/5

lv
188.68

Включва (1) Димерен превключвател Diva LED+ (по-рано C.L); координираща стенна плоча се продава отделно. Инсталира се само за 15 минути в домове от всички възрасти – НЕ СЕ ИЗИСКВА НЕУТРАЛНО. Превключвател включва/изключва осветлението до любимото ниво на осветеност. Дискретният плъзгач затъмнява и озарява светлините. Може да се използва в еднополюсни или 3-пътни приложения с механичен превключвател, където светлините се управляват от едно или две места. Патентована технология на Lutron за оптимизиране на диапазона на димиране на вашата крушка и предотвратяване на смущения с други димери в дома. Работи с до 250 вата димируеми LED/CFL крушки или 600 вата крушки с нажежаема жичка/халогенни. Осигурява над 250 нива на осветление, така че можете да създадете перфектната светлина за всяка дейност. Тестван на 1000 крушки и десетки марки за затъмняване без трептене. За списък с препоръчани крушки вижте таблицата за съвместимост.

Включва (1) Димерен превключвател Diva LED+ (по-рано C.L); координираща стенна плоча се продава отделно. Инсталира се само за 15 минути в домове от всички възрасти – НЕ СЕ ИЗИСКВА НЕУТРАЛНО. Превключвател включва/изключва осветлението до любимото ниво на осветеност. Дискретният плъзгач затъмнява и озарява светлините. Може да се използва в еднополюсни или 3-пътни приложения с механичен превключвател, където светлините се управляват от едно или две места. Патентована технология на Lutron за оптимизиране на диапазона на димиране на вашата крушка и предотвратяване на смущения с други димери в дома. Работи с до 250 вата димируеми LED/CFL крушки или 600 вата крушки с нажежаема жичка/халогенни. Осигурява над 250 нива на осветление, така че можете да създадете перфектната светлина за всяка дейност. Тестван на 1000 крушки и десетки марки за затъмняване без трептене. За списък с препоръчани крушки вижте таблицата за съвместимост.
Actuator Type Rocker
Actuator Type ‎Rocker
Batteries Included? ‎No
Batteries Required? ‎No
Brand Lutron
Brand ‎Lutron
Certification UL Listed
Certification ‎UL Listed
Circuit Type 3-way
Circuit Type ‎3-way
Color ‎Black
Connector Type Screw
Connector Type ‎Screw
Customer Reviews 4.6 4.6 out of 5 stars 142 ratings 4.6 out of 5 stars
Included Components
International Protection Rating IP54
International Protection Rating ‎IP54
Is Discontinued By Manufacturer ‎No
Item Dimensions LxWxH 1.75 x 2.2 x 4.25 inches
Item Dimensions LxWxH ‎1.75 x 2.2 x 4.25 inches
Item model number ‎DVCL-253P-BL
Item Package Quantity ‎1
Item Weight ‎2.4 ounces
Manufacturer ‎Lutron
Mounting Type Wall Mount
Mounting Type ‎Wall Mount
Number of Items ‎1
Operation Mode Off,Paddle Switch
Operation Mode ‎Off,Paddle Switch
Part Number ‎9199
Product Dimensions ‎1.75 x 2.2 x 4.25 inches
Style ‎DVCL-253P-BL
Switch Style Rocker
Switch Style ‎Rocker
Unit Count ‎1.0 Count
Voltage ‎120 Volts
Wattage ‎250 watts

3.6

11 Review
5 Star
75
4 Star
16
3 Star
3
2 Star
1
1 Star
4

Напишете вашето мнение

Вашият имейл няма да бъде публикуван. Всички задължителни полета са маркирани с*

Scritto da: Chris
Works great as a 1 way dimmer
I originally purchased two of these switches. One for a 3 way switch and one for a regular switch. The one for the regular switch works perfect with my 6" Led recessed lights. Dims well, no buzzing. Love it! On the other hand, when used with a 3 way switch It worked!....but it buzzed pretty loudly. I ended up changing out both 3 way switch dimmers because none of them worked together. Side note that I did not know when installing is to only use one dimmer per 3 way switch, not two. For some reason they still ended up loving to buzz.
Scritto da: Daddyo
Highly recommended. Works well with TorchStar LED lights.
The media could not be loaded. Purchased this at the recommendation of the tech support engineer. Bought it to replace the 150 watt version (153p) after we decided to add some additional LED lights to our basement. We installed the TorchStar ultra thin 6 inch 12 watt and 3 inch 7 watt gimballed lighting fixtures. The 150 watt version was listed as compatible with these lamps, however, torchstar tech support said that that this switch had not yet been tested or deemed compatible. On the advice of Lutron, I purchased and installed this switch to support the additional wattage. Glad to say that it is fully compatible with the installed lights, gives instant on and smooth dimming with no flickering. It is installed in a 3-way configuration. Just FYI, you only need one unit for a 3-way install. The other should be just a standard 3-way switch. I highly recommend this switch for applications over 150 watts, and less than 250.
Scritto da: NeverEnoughToys
No-hassle LED dimmer
I bought this dimmer to use with the "SleekLighting GU10 LED, 8 Watt, Dimmable ,550 lm, Light Bulb Spotlight, Recessed, Track Lighting. Ac 120v UL Listed (Pack of 4)" led bulbs that were a Gold Box buy a few weeks back (https://www.amazon.com/SleekLighting-Dimmable-Spotlight-Recessed-Lighting/dp/B0156X9416). Note that these bulbs are not on their approved list (pretty short list). This was to replace a Maestro dimmer that was already in place (it flickers with LEDs). Single pole installation was as easy as installing a switch ever could be. A few wires and screw it back in. Functionally, everything worked just as advertised. The one suggestion I have for the product managers would be that the minimum light level needs to be about half what it is now. Its pretty low now, but nowhere close to the dimness you can get with incandescent. Of course, using bulbs from the approved list may have better dimming behavior. In the end, I kept this dimmer in place over the Leviton DSM10-1LZ because it didn't flash when turning on (see my Leviton review). Even though the minimum on the Leviton was lower, I preferred a higher minimum with no flash.
Scritto da: E. Gaddy
Needs some more engineering; but looks good.
Just a little more thought would have made this product so much better. The main problem is that it is difficult to mount two or three switches like this on the same gang into an electrical box because the holes the screws go into cannot be seen after one screw is even partially in. If Lutron had provided screws an inch longer this would not have been an issue. I had to buy screws to install the switches (or spend one heck of a lot of time getting the shorter screws to work.) The unit has heat sinks that must be broken off if other switches are in the same gang. It would have been so easy to take just a little bit of metal off of the heat sinks so the switch could fit without breaking off the heat sinks. If the switch next to this switch is not a dimmer there is no reason it has to be as wide as they are. That also would have fixed the problem for some installations. The product does not dim the LED lights I have as well as the product designed for incandescent lights. When the lights are turned on they turn on then turn off and then turn on. The adjustment on the switch does not fix this. In Lutron's defense, the LEDs I have are not listed as ones that Lutron recommends or has tested.
Scritto da: Gyorgy Veres
Great product
Lutron is a great brand with great quality product. The installation is simple.
Scritto da: John in OC
Lutron phone help exceptional, and great switch too
I've done a lot of electrical work, and on install this didn't work in my 3 way setup. So why the 5 star review? Because I called the toll free Lutron number at 7PM (PDT) on a Monday night. A smart man answered, and talked me through fixing a mistake I'd made in wiring it. He stayed with me on the phone while I opened a second electrical box and described how the 2nd switch in the circuit was wired. (Incidentally, if you're replacing a 3 way switch, don't assume the wires in the box with match the colors on the dimmer- take a picture of your original switch wiring before cutting wires (duh)). Amazing. Didn't even think someone would answer the phone... Plus the switch works great and you can leave it a a dimming level you like while turning just on/off. Plus it matches similar on/off switches in the same box.
Scritto da: Charlie Webster
Works great with LED lights
We are converting our church building to all LED lighting. In the sanctuary the dimmer switches for 12 ea PAR 38 incandescent lights had to be 4" x 4" with cooling fins on the outside. Because of the way the original work was done, this resulted in a switch panel behind the audio booth that was large, and because of the location there was no good way to cover the opening into the wall and still maintain access to the wiring in that area. But the old dimmer switches don't work well with dimmable LED lights. With these we can put all the switches in a fraction of the space, sheetrock the opening, and install an access panel to easily reach wiring.
Scritto da: CaseRace
Made for led
If you have any led recessed lights. Thus is your dimmer. Other dimmers fail to fully dim the lights .. you know what I'm talking about. This one can get them down to candle light status. It's worth the few extra bucks
Scritto da: Karl
Looks Good
I'm going to give this product 3 stars because it looks good, seems to be well built, instructions are clear, etc. I did not actually use the product though. It was returned because my bulbs are not certified compatible with the dimmer. Potential customers don't get to see the instructions until the product is delivered. A heads up on the Amazon product page with a link to verified compatible equipment would be a good idea.
Scritto da: Slonar
No flickering!
Had 48 leds on one circuit that flickered with regular dimmer, with this unit no flickering at all, works as described!
Scritto da: Celia
did not work returning product
Did not work on LED lights I purchased from Amazon even though product says it accepts dimmer, so I am returning

Свързани продукти

Открийте нашата международна мрежа

Изпращаме до 28 държави, над 200 000 продукта. Бъдете в течение, абонирайте се за бюлетина.

Array