Arnold 12-инчово стоманено колело Оne Раск

Brand:Arnold

3.3/5

lv
156.82

Ако искате вашето външно захранващо оборудване да издържи по-дълго и да направи повече, искате части, аксесоари и приставки на Arnold. Осигурявайки ви голямо разнообразие от безпроблемни продукти с най-високо качество, частите на Arnold ще поддържат цялото ви оборудване във възможно най-добрата форма. Съвместим с тонове големи марки, 50+ години доказана производителност донесе на Арнолд репутация на авангардни продуктови иновации и обширна инженерна експертиза. От основна поддръжка до основни иновации, Arnold разполага с всичко необходимо, за да поддържа оборудването да работи както трябва сезон след сезон. С Arnold можете да сте уверени в надежден продукт с точно прилягане, дизайн, материал и конструкция. В допълнение към надеждните части и аксесоари, лесните за следване инструкции и допълнителни съвети на Arnold ще улеснят поддръжката на вашето оборудване и ще ви гарантират, че ще свършите работата както трябва.

Няма налични единици
Оребрени колела с 1/2 сачмен лагер. 90 lb. Товароносимост. 2-3/16 дължина на главината. 1/2 диаметър центрирана главина. Стоманено колело 12 x 1,75.
Assembly required No
Batteries required No
Brand Arnold
Country of Origin USA
Customer Reviews 4.2 4.2 out of 5 stars 151 ratings 4.2 out of 5 stars
Diameter 12 Inches
Domestic Shipping This item is available for shipping in the U.S. except for California and to select countries outside the U.S.
Exterior Finish Alloy Steel
Included Components wheel
International Shipping This item can be shipped to select countries outside of the U.S. Learn More
Is Discontinued By Manufacturer No
Item model number 1275-B
Item Weight 4.5 Pounds
Manufacturer ARNOLD
Material Steel
Product Dimensions 12 x 12 x 2 inches
Rim Size 12 Inches
Size Оne Расk
Wheel Backspacing 6.75 Inches
Wheel Size 12 Inches

3.3

8 Review
5 Star
63
4 Star
15
3 Star
12
2 Star
3
1 Star
6

Напишете вашето мнение

Вашият имейл няма да бъде публикуван. Всички задължителни полета са маркирани с*

Scritto da: Pat Belanger
Good old-quality
Needed these wheels to replace two that, after 40 years, were finally worn out. I was delighted to find these to be of the same quality as the originals. I expect these to provide me with another 40 years of service.
Scritto da: irishman
This would be nice to know before hand
as I did not know the hub width I ordered the wheels, but found them to wide to use . This would be nice to know before hand.
Scritto da: WILLIAM BUDRIS
Good Replacement Wheels on My Older Troy Bilt Push Mower.
I Replaced the rear 12" wheels on my Troy Bilt push mower 3 years ago. Already, one wheel had begun to break. Rather than replace them with another expensive set of cheap plastic wheels, I decided to try these. After shimming each of them with 3 washers, they work perfectly. They are a somewhat heavier, but roll more smoothly, are cheaper &, I believe, more long lasting than the plastic wheels.
Scritto da: Amazon Customer
Great price and heavy duty wheel.
This wheel won't crack. It is wider than previous craftsman wheel though. Needs longer bolt to fit.
Scritto da: DAVE B.
Quality
Steel hub not plastic
Scritto da: SHERRY M
Met expectations!
Very sturdy tire. Used for dock wheels.
Scritto da: Cid
They Roll!!
What's not to like?? They did the job!!
Scritto da: Juan Cobas
How to make it fit
I bought these wheels in August 2013 and the are steel and strong. Some old reviews said the wheels were to wide, this is not exactly true. Place a wheel on the axle and you may only have a thread or 2 showing. Put on the nut and tighten it a bit until a washer will also fit. Then tighten with the washer on until the wheel bends into the desired location. Remove the washer and nut, put some locktite on the threads. I then sprayed on a little WD40 on each end of the wheel put on the washer and nut, a year latter it works fine.

Свързани продукти

Открийте нашата международна мрежа

Изпращаме до 28 държави, над 200 000 продукта. Бъдете в течение, абонирайте се за бюлетина.

Array